ISO/TR TECHNICAL REPORT 11064-10 First edition 2020-09 Ergonomic design of control centres Part 10: Introduction to the control room design series of standards Conception ergonomiquedes centresdecommande- Partie 10: Introduction aux series de normes relatives a la conception des centres de commande Reference number IS0/TR11064-10:2020(E) ISO @ISO 2020 IS0/TR11064-10:2020(E) COPYRIGHTPROTECTEDDOCUMENT @IS02020 All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting below or Iso's memberbody in the country ofthe requester. ISO copyright office CP 40i : Ch.de Blandonnet 8 CH-1214 Vernier, Geneva Phone: +41 22.749 01 11 Email: [email protected] Website: www.iso.org Published in Switzerland ii @ IS0 2020 - All rights reserved IS0/TR11064-10:2020(E) Contents Page Foreword ..iv Introduction .. 1 Scope. ..1 2 Normativereferences ..1 3 Termsand definitions 4 Selecting the appropriate standard to use ..1 5 Summary of parts .2 5.1 General .2 5.2 IS011064-1,Principleforthedesignofcontrolcentres 2 5.3 IS011064-2,Principlesofcontrol suitearrangement 3 5.4 .3 Is011064-3,Control roomlayout. 5.5 IS011064-4,Workstationlayoutanddimensions .3 5.6 IS011064-5,Displaysandcontrols .4 5.7 Is011064-6,Environmental requirementsforcontrolrooms 4 5.8 IS011064-7,Principlesfortheevaluationofcontrolcentres .5 5.9 Human-centred design process for interactive systems (IS0 9241-210) .5 5.10 Ergonomic requirementsforpeoplewith special needs .5 AnnexA (informative)Overviewof theIS09241series .6 Bibliography 7 @ IS0 2020 - All rights reserved ili