论文标题
绝对湿度,温度和种群密度对COVID-19的蔓延和衰减持续时间的影响:日本的多恢复研究
Influence of Absolute Humidity, Temperature and Population Density on COVID-19 Spread and Decay Durations: Multi-prefecture Study in Japan
论文作者
论文摘要
这项研究分析了日本不同县的Covid-19大流行的传播和衰减持续时间。在大流行期间,负担得起的医疗保健在日本已广泛使用,医疗系统没有崩溃,从而使县之间进行了准确的比较。对于本研究中包含的16个县,每天的最大确认病例超过10例,在大多数县中,每日确认的病例的数量遵循钟形或对数正态分布。在扩散持续时间和衰减持续时间之间观察到了良好的相关性。但是,在从外国返回的旅行者返回的地区,这些例外被定义为感染群集的起源。除了这些县外,人口密度被证明是影响扩散和衰减模式的主要因素,R2 = 0.39(p <0.05)和0.42(p <0.05),大约对应于社会距离。发现最大绝对湿度会影响人口密度归一化的衰减持续时间(R2> 0.36,p <0.05)。我们的发现表明,根据对最大绝对湿度,环境温度和人口密度的多元分析的估计流行持续时间(调整后的R2 = 0.53,p值<0.05)可以证明对潜在的未来大流行中的干预计划有用,包括第二次共核199爆发。
This study analyzed the spread and decay durations of the COVID-19 pandemic in different prefectures of Japan. During the pandemic, affordable healthcare was widely available in Japan and the medical system did not suffer a collapse, making accurate comparisons between prefectures possible. For the 16 prefectures included in this study that had daily maximum confirmed cases exceeding ten, the number of daily confirmed cases follow bell-shape or log-normal distribution in most prefectures. A good correlation was observed between the spread and decay durations. However, some exceptions were observed in areas where travelers returned from foreign countries, which were defined as the origins of infection clusters. Excluding these prefectures, the population density was shown to be a major factor affecting the spread and decay patterns, with R2=0.39 (p<0.05) and 0.42 (p<0.05), respectively, approximately corresponding to social distancing. The maximum absolute humidity was found to affect the decay duration normalized by the population density (R2>0.36, p <0.05). Our findings indicate that the estimated pandemic spread duration, based on the multivariate analysis of maximum absolute humidity, ambient temperature, and population density (adjusted R2=0.53, p-value<0.05), could prove useful for intervention planning during potential future pandemics, including a second COVID-19 outbreak.