ISO INTERNATIONAL STANDARD 9374-4 First edition 1989-10-15 ANSI Internar Doc Sect Cranes - Information to be provided - Part 4 : Jib cranes Appareils de levage a charge suspendue -- Informations a fournir - Partie4:Grues a fleche Reference number ISO 9374-4:1989 (E) No reproduction or networking permited without license from IHS Not for Resale ISO 9374-4 : 1989 (E) Foreword ISo (the International Organization for Standardization) is a worldwide federation of national standards bodies (isO member bodies). The work of preparing International Standards is normally carried out through Iso technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, govern- mental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for approval before their acceptance as International Standards by the ISo Council. They are approved in accordance with ISO procedures requiring at least 75 % approval by the member bodies voting. International Standard ISO 9374-4 was prepared by Technical Committee ISO/TC 96, Cranes. Iso 9374 will consist of the following parts, under the general title Cranes - Informa- tion to be provided: Part 1: General Part 2: Mobile cranes - Part 3: Tower cranes Part 4: Jib cranes -Part 5: Overhead travelling cranes and portal bridge cranes Annex A forms an integral part of this part of ISo 9374. ?ISO 1989 All rights reserved. No part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from the publisher. International Organizationfor Standardization Casepostale56·CH-1211Geneve20·Switzerland Printed in Switzerland No reproduction or networking permitted without license from IHS Not fr Resale ISO9374-4:1989(E) INTERNATIONAL STANDARD Cranes -- lnformation to be provided - Part 4 : Jib cranes Scope 3 Information to be provided by the This part of Iso 9374 specifies information to be provided purchaser with enquiry or order a) by a purchaser in enquiring for or ordering a jib crane; The purchaser shall provide the information given in annex A to and enable the crane manufacturer to offer or to supply the most suitable jib crane and equipment to satisfy the duty b) by a manufacturer in tendering for or supplying a jib requirements and service conditions, including clearance crane. requirements based on figure 1. 2 Normative references The following standards contain provisions which, through 4 Information to be provided by the reference in this text, constitute provisions of this part of ISo 9374. At the time of publication, the editions indicated manufacturer were valid.All standardsare subjectto revision,and parties to agreements based on this part of iso 9374 are encouraged to investigate the possibility of applying the most recent editions 4.1 Technical information of the standards indicated below. Members of IEC and ISO maintain registers of currentlyvalid International Standards. The manufacturer shall provide technical information and test certificates for the crane to facilitate its installation, testing and Iso 4301-1 : 1986, Cranes and lifting appliances - Classifi- use in accordance with ISo 7363 and as appropriate for the ap cation-Part 1:General. pliance. iso 4301-4 : 1989, Cranes and related equipment - C Classifi- cation - Part 4: Jib cranes. 4.2 Dimensions Iso 7363 : 1986, Cranes and lifting appliances -- Technical characteristics and acceptance documents. The manufacturer shall give the dimensions shown in figure 2. ational Organization for Standardization NoreproductionornetworkingpemitedwithoutlicensefromHS Not fo