ISO INTERNATIONAL STANDARD 21308-5 First edition 2014-01-15 Road vehicles Product data exchange between chassis and body work manufacturers (BEP) - Part 5: Coding of loader crane bodywork Vehicules routiers - Echange de donnees de produit entre les fabricants de chassis et de carrosseries (BEP) - Partie 5: Codage des grues de chargement Reference number IS0 21308-5:2014(E) LSO @ IS0 2014 I without license from IHS Not for Resale IS0 21308-5:2014(E) COPYRIGHTPROTECTEDDOCUMENT @ IS0 2014 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56:CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ IS0 2014 - All rights reserved No reproductic networking permited without license from IHS Not for Resale IS0 21308-5:2014(E) Contents Page Foreword ..iv Introduction. ..V 1 Scope. .1 2 Normative references ..1 3 Terms and definitions 4 Coding principles ..6 4.1 BEP codes of loader cranes .6 4.2 Units of BEP code values. 4.3 References for measurements. ..8 5 Coding of geometrical data and space requirements. ..14 5.1 Mounting positions of crane and auxiliary stabilizers ..14 5.2 Dimensional interfaces for connections to sub-frame and chassis .15 5.3 Crane base dimensions, stabilizers, and lower space requirements .17 5.4 Boom system dimensions and space requirements above mounting plane .26 5.5 Crane slewing space requirements 35 5.6 Auxiliarystabilizerdimensions .37 6 Coding of masses .41 6.1 Mass points in transport position .41 6.2 Masses with distances in working mode for stability calculations .43 7 Coding of forces and moments .45 8 Coding of general crane data .45 8.1 General crane data. ..45 8.2 Mechanical interfaces .46 8.3 Hydraulics equipment and interfaces .47 8.4 Electrical/electronic equipment and interfaces ..48 8.5 Load lifting attachments. 48 Annex A (normative) XML coding related to this part of IS0 21308 .49 Bibliography .51 iii Stal se with ISt thout license from IHS Not for Resale